Braided Shield Brushing Machine

The shielding net can be brushed smoothly to facilitate later processing;

The wire rod is slowly put in o the front section by holding the wire rod, and the hand-held wire rod is rotated slowly;

When brushing the shielding net,

it should be slowly brushed back from the front end (the principle of combing hair is the same)

The wire can be pulled back and forth to increase friction, that is to brush the knot.

Different sizes of wire can adjust the spacing between the track brush wheels.

When brushing the large square wire harness,

the front section of the shielding net can be peeled off about 30 (to prevent the front section hidden in the wire core from knotting) and the shielding net will not be shorter than the stripping mouth when brushing smoothly.

In order to ensure the safety and durability of the controller,

please do not switch between the positive and negative directions frequently during the operation of the motor,

and do not start the motor when the governor is in the high speed position.

Please adjust the governor every time you stop the motor. When you start again,

accelerate again, so that the original controller is very durable.